Car Won’t Start But Clicks? Tips to Diagnose and Fix the Issue – Honda Pilot

YouTube video

If you’ve found yourself in a situation where your car won’t start but only clicks, don’t panic. This is a common issue that can be easily diagnosed and fixed. In this article, we will guide you through the steps to identify the problem and provide possible solutions.

Step 1: Checking the Fuel Pump

The first thing you should do when your car won’t start is to check if the fuel pump is running. You can do this by turning the key to the on position and listening for the sound of the fuel pump. In most vehicles, the fuel pump should run for a few seconds when the key is turned on.

If you are unable to hear the fuel pump from inside the car, you can move to the outside and place a camera near the rear wheel to see if the sound can be picked up. This will help determine if the fuel pump is functioning properly.

Step 2: Checking the Starter

If the fuel pump is working correctly, the next step is to check if the starter is getting any power. The starter is located near the transmission dipstick, and it can be difficult to access. However, with a bit of effort, you should be able to get a good view of it.

When you turn the key and hear a clicking sound, it is an indication that the starter is trying to engage. To verify this, you can use a load test tool to check the battery’s voltage while cranking the engine. A voltage drop of more than 0.5 volts may suggest a faulty starter.

Step 3: Diagnosing the Battery

Before replacing the starter, it is essential to check the battery’s condition. Even if the battery is weak, it may still have enough power to start the car. You can measure the battery’s voltage, and anything over 12 volts is considered adequate for starting the engine.

To determine how much the voltage drops during cranking, you can connect the load test tool to the battery and observe the voltage change. A voltage drop of more than half a volt indicates a potential issue with the starter or battery terminals.

Step 4: Identifying the Problem

Based on the previous steps, you can now diagnose the problem. If you hear the fuel pump running and the starter clicking, it is likely that the starter motor needs to be replaced. In this case, it is advisable to seek professional help to ensure the correct installation of the new starter.

However, if you hear the fuel pump but no clicking from the starter, there may be an issue with the relays. Further troubleshooting is required to identify and fix the problem.

Key Points to Remember

  1. Always check if the fuel pump is running when troubleshooting a no-start issue.
  2. Listen for clicking sounds from the starter when attempting to start the car.
  3. Use a load test tool to measure the voltage drop during cranking.
  4. A voltage drop of more than 0.5 volts suggests a faulty starter.
  5. If the fuel pump runs and the starter clicks, it is likely that the starter motor needs to be replaced.
  6. Seek professional assistance for replacing the starter to ensure proper installation.
  7. If the starter doesn’t click but the fuel pump is running, further diagnosis is required.

By following these steps, you can effectively diagnose and fix a car that won’t start but only clicks. It is important to remember that these steps are specific to the Honda Pilot, but they can be applied to other vehicles as well. If you encounter any difficulties during the process, it is recommended to consult a professional mechanic to ensure accurate troubleshooting and repairs.

We hope this article has been helpful in guiding you through the process of diagnosing and fixing a no-start issue in your Honda Pilot. If you have any further questions or concerns, please leave them in the comments below. Don’t forget to subscribe to our channel, GarageKing, for more informative videos.